Step by Step
Fax/DID Module
108
Fax/DID Mode
In this mode of operation the module detects fax
signals, and extensions or digits entered. When an
external call is answered, a greeting announcement is
played to guide the caller. An example of a recorded
announcement would be: "You have reached Siemens.
To send a fax start transmission now. For Sales Depart-
ment dial 22. For Technical Support dial 23." If no valid
fax signal, digit or extension is detected within 10
seconds of the greeting announcement, a second
announcement will be played and the call will be trans-
ferred to an Attendant.
Announcement Mode
When an external call is answered, a greeting
announcement is played and the call is transferred to an
attendant. An example of a recorded announcement
would be: "You have reached Siemens. Your call is being
transferred."
Call Answering Menu
The Fax/DID module allows you to create a customized
Call Answering Menu as well as transfer a call to a
specific extension or group by prompting the caller to
enter a digit.
A call is transferred to a preconfigured destination after
3 seconds. If a digit is entered before this period of
time, it will be analyzed and the call will be forwarded to
a new destination. The destination can be an extension
or a group.
When the Call Answering Menu is not configured, the
Fax/DID module can only identify extension and group
numbers.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... or Select a digit for Call Forwarding.
Enter an extension or Subscriber Group number to be
assigned to the digit (e.g., 12/780).
0 0 9
0 9
*
To Next Page
Loading...
