Siemens HiPath 1130 - Programming an Extension; Pickup Groups; Alert Ring Timeout for Pickup Groups

Programming an Extension
43
Step by Step
Programming an Extension
Pickup Groups
Extensions can be grouped into a maximum of 16
Pickup Groups. This allows an extension to answer calls
that ring at other extensions belonging to the same
Pickup Group.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Enter the number of the Pickup Group (01 to 16).
... Configure extensions for a Pickup Group (e.g., 11/101).
Press this key.
Initial state for Programming Mode.
Deleting Extensions from a Pickup Group
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Enter the number of the Pickup Group (01 to 16).
Delete the extensions in the call Pickup Group.
Press this key.
Initial state for Programming Mode.
Alert Ring Timeout for Pickup Groups
If a call is not answered within a specified period of
time, a short alert ring is sent to the Pickup Group (see
also Pickup Groups).
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
4 3
0 1 1 6
#
You can also add extensions to an existing Pickup
Group.
4 3
0 1 1 6
*
#
0 3 5