Siemens HiPath 1130 - Multiplier for Call Charge Factor; Extension Call Charge Factor

General Programming
83
Step by Step
Enter the decimal separator position (0 to 4)
For example, for $ 0.12: 00012 and 2
For example, for $ 2.00: 00002 and 0
Initial state for Programming Mode.
Multiplier for Call Charge Factor
This setting specifies the multiplier for Call Charge
factors.
The default setting specifies that each pulse be multi-
plied by 1 for both factors.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
or Select a Call Charge factor:
= Factor 1
= Factor 2
... Select a pulse multiplier.
Initial state for Programming Mode.
Extension Call Charge Factor
This setting specifies if there is a factor for billing the
users.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter the extension number (e.g., 11/101).
... Select a billing factor for the extension:
= None (default) - equivalent a billing value of x1
= Factor 1
= Factor 2
Enter the next extension number
or
4 20
1 2
1
2
0 00 5 42
0 4 3
1 3
1
2
3