Siemens HiPath 1130 - Caller ID (CLIP) on an Analog Line

Programming an External Line
33
Step by Step
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter a number for an external analog line (e.g., 801).
... Select the type of protocol:
= LOOP seizure (default for "other countries")
= GROUND seizure (default for Canada)
Press this key.
Initial state for Programming Mode.
Caller ID (CLIP) on an Analog Line
HiPath 1100 systems are capable of receiving Caller ID
information through FSK and DTMF protocols over
analog lines. This service must be activated by the local
carrier.
The default setting depends on the country.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter a number for an external analog line (e.g., 801).
... Select the type of protocol:
= Disabled
= DTMF1 Brazil
= DTMF2 ETSI
= FSK
Enter the next external line number.
or
Press this key.
Initial state for Programming Mode.
0
1 7
1 2
1
2
#
When using the GROUND option for Canada, the
"Polarity Reversal" feature for these external lines
must be disabled.
0 0 5
0 3
0
1
2
3
#