Siemens HiPath 1130 - Activating Remote Administration; Configuring an External Number; Remote Administration Password

Step by Step
General Programming
94
Activating Remote Administration
This setting allows the system to be administered
remotely.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
or Activate/Deactivate Remote Administration:
= To activate
= To deactivate (default)
Initial state for Programming Mode.
Configuring an External Number
This specifies external numbers (Service MSN without
external access code 0) that are able to perform
Remote Administration.
The default configuration does not specify a MSN.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Select a slot for the external number (1 to 4).
Enter the external number (up to 20).
... Select the next slot for an external number.
or
Press this key.
Initial state for Programming Mode.
Remote Administration Password
This feature assigns a password for enabling Remote
Administration using a specified external number
(Service MSN).
The default configuration does not specify a password.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 6 6
*
#
*
#
0 6 7
1 4
1 4
#
0 6 8