Siemens HiPath 1130 - Assigning Extensions to MOH Groups; Music Source for a MOH Group

Step by Step
General Programming
78
Assigning Extensions to MOH Groups
Extensions can be grouped in two MOH groups.
No extensions configured as a default.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
or Select Group 1 or 2.
Enter the extension numbers (e.g., 11/101).
Press this key.
Initial state for Programming Mode.
Deleting Extensions in a Group
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
or Select Group 1 or 2.
To delete all extensions in the group.
Press this key.
Initial state for Programming Mode.
Music source for a MOH Group
When an extension has a call on hold, the caller will hear
the music programmed for that extension’s group.
Enter the code for programming.
or Select Group 1 or 2.
... Enter the code for a music source:
= No music (default)
= To activate external music source.
= To activate an external music source connected to
an extension.
= To activate an internal music source.
= To activate an internal PCM source
8 70
1 2
#
8 70
1 2
*
#
8 80
1 2
0 4
0
1
2
3
4