Siemens HiPath 1130 - Remote Administration; Service Call; Remote Software Update; Remote Operation Mode

General Programming
93
Step by Step
Remote Administration
Service Call
This feature allows you to call a service center and let
administration be carried out remotely, through the call
established.
Enter this code.
Enter the service center number.
Enter to confirm.
Wait for a confirmation tone.
Remote Software Update
If authorized, the software can be update remotely.
Enter this code.
Wait for a confirmation tone.
The software is sent by the service center.
Remote Operation Mode
This specifies the remote updating of the software. The
update can be carried out remotely over external digital
ISDN lines and analog lines connected to a modem.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
or Select the operating mode:
= Via ISDN (default)
= Via modem
Initial state for Programming Mode.
9
*
9
4
#
4
*
9
1 5
0 8 4
1 2
1
2