Siemens HiPath 1130 - Local SW Update; Activating a Software Update; Day for SW Update; Time for SW Update

Step by Step
General Programming
86
Local SW Update
This feature initiates the download of the last software
version released for the PC and then downloads the
update for the exchange.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Initial state for Programming Mode.
Activating a Software Update
This feature allows you to update the system’s software
automatically over an ISDN network on a scheduled
date.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
or Activate/Deactivate software update:
= To activate
= To deactivate (default)
Initial state for Programming Mode.
Day for SW Update
This setting specifies a day for starting the data transfer.
The default setting for the update to start is day 01.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter the day for starting the transfer.
Initial state for Programming Mode.
Time for SW Update
This setting specifies the time of day for starting the
data transfer on the specified day.
0 6 0
0 5 5
*
#
*
#
0 5 4
d d