Siemens HiPath 1130 - COS Changeover; Required: Programming Mode Must be Active

Step by Step
Main Configurations
26
: Enter COS for Day Service
: Enter COS for Night Service
Instead of entering or enter the following COS:
= No Trunk Access (No Permission)
= Outward-Restricted Trunk Access with Denied
List 1 (4 entries)
= Outward-Restricted Trunk Access with Denied
List 2 (10 entries)
= Outward-Restricted Trunk Access with Denied
List 3 (35 entries)
= Outward-Restricted Trunk Access with Permis-
sion List 1 (4 entries)
= Outward-Restricted Trunk Access with Permis-
sion List 2 (10 entries)
= Outward-Restricted Trunk Access with Permis-
sion List 3 (25 entries)
= Unrestricted Trunk Access (default for all lines)
... Enter the extensions (e.g., 11/101) to which the COS
selected will be assigned.
Press this key.
Initial state for Programming Mode.
To assign a COS to additional lines, repeat the program-
ming steps described above.
COS Changeover
You can allow or deny a temporary COS Changeover
from an extension to a different extension.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter the extension number (e.g., 11/101).
or To allow/deny COS Changeover:
= To allow
= To deny (default)
D
N
D N
0
1
2
3
4
5
6
7
#
7 8
*
#
*
#