Siemens HiPath 1130 - General Programming; Music on Hold

General Programming
77
Step by Step
General Programming
Music on Hold
You can enter music for external calls that are placed on
hold (MOH) using a music source:
• Internal: The caller on hold hears music generated
by the system.
• External: The caller hears music from an external
music source (e.g., a radio) connected directly to the
system’s external music input.
• External connected to an extension: The caller hears
music from an external music source (e.g., a radio)
connected to an extension.
In order to accomplish this, add extensions in two MOH
groups or do not assign any extension.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Enter the code for a music source:
= No music
= To activate an external music source
= To activate an external source - extension
= To activate an internal source (default)
= To activate an internal PCM source
Initial state for Programming Mode.
3 6
0 4
0
1
2
3
4
Code 36 is used when there is no group
assigned to the extension.