Siemens HiPath 1130 - Entrance Telephone; Configuring an Entrance Telephone

Step by Step
Entrance Telephone
98
Enter the MSN number selected:
Example
User is at his/her office (3416496):
= This specifies that the MSN number must be
used for other features (e.g., 3415565)
= This specifies that an MSN slot (001 ... 140) must
be used for other features (e.g., 001)
Initial state for Programming Mode.
Replace the handset.
At his time, the called destination receives the informa-
tion that the calling number is 3415565, even though
the call has been originated from number 3416496.
Entrance Telephone
Configuring an Entrance Telephone
With the HiPath 1100 you can connect up to four
Entrance Telephones in extension slots. Each Entrance
Telephone must be individually activated in the system.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Select a slot for the Entrance Telephone extension (1 to
4).
Enter the analog extension number (e.g., 12/102) to be
enabled as an Entrance Telephone.
Repeat these steps for any additional slot.
or
Press this key.
Initial state for Programming Mode.
Slot MSN
001 3415565 - Home
002 3416496 - Office
1
2
1 5
1 4
#