Programming an External Line
31
Step by Step
Warning Tone for Calls without LCR
This feature alerts the user to the fact that the call
HiPath 1100 being made may be charged by the Carrier
at a higher rate than usual. This may be due to the
unavailability of an external line for LCR (Least Cost
Routing).
When using a standard telephone, a warning tone
indicates to the user that a different carrier is complet-
ing the call at this time. When using a system
telephone, the carrier’s name will show on the display.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
or Activate/Deactivate Tone:
= To activate
= To deactivate (default)
Initial state for Programming Mode.
Programming an External Line
Groups of external lines
Programming allows access to an external line or group
of external lines through a code other than "0."
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
or a Enter the group code number (default is 0).
Enter a number for an external line (e.g., 801).
Press this key.
Initial state for Programming Mode.
0
9
2
*
#
*
#
In order to use this feature the HiPath 1100 must
have been enabled for LCR (programmed via
HiPath 1100 Manager).
5 6
0 8
9 0
8
9 9
#
To Next Page
Loading...
