Entrance Telephone
99
Step by Step
Deleting an Entrance Telephone Assignment
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Enter the slot to be deleted.
Delete the assignment of the Entrance Telephone to
the extension.
Enter the next slot.
or
Press this key.
Initial state for Programming Mode.
Door Lock
This feature detects when there is a locking device
installed.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
... Enter the slot for the TFE Interface where the lock is
located (1 to 4).
or Activate/Deactivate the Door Lock:
= To activate
= To deactivate (default)
Repeat these steps for any additional slot.
1 5
1 4
*
#
1. By default no slot is set as an Entrance Tele-
phone.
2. Each TFE Interface Module can be connect-
ed to one Entrance Telephone only.
3. Each TFE Interface Module serves as an
interface for an Entrance Telephone or or
Pager. To provide these two interfaces two
modules must be used.
1 6
1 4
*
#
*
#
To Next Page
Loading...
