Siemens HiPath 1130 - Search Mode for Hunt Groups

Step by Step
Programming an Extension
54
Deleting extensions from Hunt Groups
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter the Hunt Group number (780 to 789)
Delete all extensions in the Hunt Group.
Press this key.
Initial state for Programming Mode.
Search Mode for Hunt Groups
This setting specifies how each Hunt Group will
conduct a search for an available extension: linear or
round-robin search
• A linear search always starts from the first extension
in the group.
• A round-robin search starts after the last extension
selected.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter the Hunt Group number (780 to 789).
or Select the search mode:
= Linear (default)
= Round-robin
Enter the next Hunt Group number
or
Press this key.
Initial state for Programming Mode.
2 10
*
#
0 2 2
1 2
1
2
#