Programming an External Line
35
Step by Step
External Line Call Direction
When a user tries to access a line, lines that have been
previously programmed as outgoing are given priority. If
an incoming call is received over that line, however, it
will come through as usual.
To avoid this situation the method for accessing external
lines can be defined at the time of making or receiving
a call. This facility is usually contracted with the local
carrier to ensure optimal usage of all lines available.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter a number for an external line (e.g., 801).
... Enter the number for the type of access to an external
line:
= Bidirectional (default)
= Unidirectional incoming
= Unidirectional outgoing
Enter the next external line number.
or
Press this key.
Initial state for Programming Mode.
Flash Duration
The duration of the Flash signal that is sent by the
system to each external analog line can be configured
individually. Flash signal duration depends on the
specific setting for each country.
If the country configuration(Æ page 27) or the type of
external analog line (Æ page 17) is changed, the Flash
Duration will automatically reset to the default value.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter a number for an external analog line (e.g., 801).
5 5
1 3
1
2
3
#
1 8
To Next Page
Loading...
