Main Configurations
19
Step by Step
= Day Service
= Night Service
= Day Service after a specified time period
= Night Service after a specified time period
... Enter the extension numbers (e.g., 11/101) or call
groups that should signal when receiving calls from the
specified external line (up to 10 extensions or 1 group).
Press this key.
Initial state for Programming Mode.
To assign an extension as an attendant for different
lines, repeat the programming steps.
Deleting Attendants for an External Line
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter a number for an external analog line (e.g., 801).
The selected line attendant will be deleted.
Press this key.
Initial state for Programming Mode.
1
2
3
4
#
If an extension is connected to a Door Opener, it
cannot be configured as an attendant.
Within a Subscriber Group an incoming call rings
at the first extension available, according to the
call distribution plan configured for the UCD
Subscriber Group.
When there is no First Attendant configured, the
call is forwarded to the Overflow extension. If an
Overflow extension has not been configured, the
call is terminated and does not ring at any exten-
sion, neither can it be captured. When this
occurs, the system waits until the external line is
made available by the Carrier.
4 2
*
#
To Next Page
Loading...
