Prepare Engineering
176 SICAM RTUs, SICAM AK 3 User Manual
Edition 07.2016, DC2-028-2.03
3.4 SD Card
SICAM AK 3 uses a SD card for the storage of engineering data and firmware codes for the
used system elements (e.g. master control element, protocol elements). This is located on the
master control element.
Designation Item-Number/MLFB
SD Card CC6-095
6MF12131GA050AA0
3.4.1 SD Card Reader/Writer
For archiving purposes, the engineering data and firmwares stored on the SD card can be
read with a standard commercial chip card reader and be stored on a PC. On the other hand,
in particular for the initialization of a target system, the data can be written from a PC to the
SD card.
The driver software required for the use of the chip card reader must be installed previously
on the PC. Follow thereto the instructions of the manufacturer.
The SD card must be formatted with the file system FAT16.
To Next Page
Loading...
