Siemens SICAM RTU - Import Firmware; Parameterization of the Telecontrol Functionality

Engineering via SICAM TOOLBOX II
SICAM RTUs, SICAM AK 3 User Manual 187
DC2-028-2.03, Edition 07.2016
4.1.4 Import firmware
For the parameterization of the functionality of a target system, the firmware codes of the re-
quired system elements must be present in the SICAM TOOLBOX II.
You can import the required firmwares - if not yet present - into the data base of the
SICAM TOOLBOX II with the tool "Master Data Update". You find the corresponding files in
the internet under www.siemens.com/sicam (see section 3.5, Loadable Firmwares). Further
information about this can be found in section 5.5.1.2, Import of Firmware into the
SICAM TOOLBOX II.
4.1.5 Parameterization of the Telecontrol Functionality
The entire parameterization for the telecontrol function can be performed in the
SICAM TOOLBOX II with the tool "OPM II". You find the detailed instruction thereto in the
SICAM TOOLBOX II Online Help, chapter "OPM II".
The description of the system-technical and process-technical settings can be found in the
manual SICAM RTUs Common Functions System and Basic System Elements, chapter
"Telecontrol".
Note
In the SICAM TOOLBOX II Online Help resides a video demonstration for the parameterization of
SICAM EMIC (section "System Technique", "SICAM RTUs", "SICAM EMIC").