Siemens SIMATIC HMI series User Manual

Parameterizing the Mobile Panel
5.8 General settings
Mobile Panels 2nd Generation
Operating Instructions, 09/2018, A5E33876626-AC
103
5.8 General settings
5.8.1 Regional and language settings
The date, time and decimal points are displayed differently in different countries. You can
adapt the display format to meet the requirements of various regions. The country-specific
settings apply to the current project. If the project language is changed, the country-specific
settings are also changed.
Requirement
The Control Panel is open.
Procedure
1. Open the "Regional and Language Settings" dialog using the "Regional Settings" icon.
①
"Region" selection box
2. Select the required region in the selection box ①.
3. Navigate to the "Number", "Currency", "Time" and "Date" tabs one after the other.
4. Set the required regional settings in the selection field of these tabs.
5. Confirm your entries.
The dialog closes.
The country-specific specifications for the HMI device are now set.
"Setting the date and time (Page 104)" describes how to activate daylight saving time.

Siemens SIMATIC HMI series Specifications

General

Series	SIMATIC HMI
Category	Control Panel
Display Type	TFT LCD
Touch Screen	Yes (resistive or capacitive, depending on model)
Processor	Varies by model (e.g., ARM-based processors)
Storage	Varies by model (e.g., Flash memory, microSD card slot)
Communication Interfaces	Ethernet, USB
Protection Class	IP65 (front panel), depending on model
Operating Temperature	0 to 50°C, -20 to 60°C
Power Supply	24 V DC
Memory	128 MB, 256 MB