Mobile Panels 2nd Generation
Operating Instructions, 09/2018, A5E33876626-AC
31
General safety instructions
The device is designed for operation in industrial areas for operator control and monitoring of
plant processes.
Personal injury or material damage due to non-compliance with safety regulations
Failure to exactly comply with the safety regulations and procedures in this document can
result in hazards and disable safety functions. This can result in personal injuries or
material damage.
Closely follow closely the safety regulations and procedural instructions in each situation.
Observe the safety and accident prevention regulations applicable to your application in
addition to the safety instructions given in this document.
Safety during configuration and operational safety of the plant
Personal injury or material damage due to improper configuration of the plant
The configuration engineer for plant control must take precautions to ensure that an
interrupted program will be correctly integrated again after communication failures, voltage
dips or power outages.
A dangerous operating state must not be allowed to occur - not even temporarily - during
the entire execution of the control program, even during a troubleshooting.
To Next Page
Loading...
