Siemens SIMATIC HMI series User Manual

Parameterizing the Mobile Panel
5.15 Functions for service and commissioning
Mobile Panels 2nd Generation
Operating Instructions, 09/2018, A5E33876626-AC
159
5.15.6
Editing IP addresses and communication connections
5.15.6.1
Overview
This section describes how you can, from your HMI device, change the IP addresses of
controllers and other HMI devices in the subnet of your HMI device and adapt the associated
communication connections accordingly. This gives you the ability to create a project,
transfer it to multiple HMI devices and then adapt the respective controller connections
without changing the project.
If you change the IP addresses of other devices in the subnet of your HMI device, the
following steps are required:
● Update IP address and device name; see section
"Assigning IP address and device name (Page 160)"
● Update communication connection; see section
"Configuring a communication connection (Page 162)".
The following functions are also available:
● A scan function to list the HMI devices and PLC in the subnet.
● Filter function for the scan results
● Check assignment of IP addresses and device names for HMI devices and PLCs.
● Project IP addresses and device names for HMI devices and PLCs can be restored.

Siemens SIMATIC HMI series Specifications

General

Series	SIMATIC HMI
Category	Control Panel
Display Type	TFT LCD
Touch Screen	Yes (resistive or capacitive, depending on model)
Processor	Varies by model (e.g., ARM-based processors)
Storage	Varies by model (e.g., Flash memory, microSD card slot)
Communication Interfaces	Ethernet, USB
Protection Class	IP65 (front panel), depending on model
Operating Temperature	0 to 50°C, -20 to 60°C
Power Supply	24 V DC
Memory	128 MB, 256 MB