Siemens SIMATIC HMI series User Manual

Installing system components
3.3 Installing the connection box standard and connection box advanced
Mobile Panels 2nd Generation
46 Operating Instructions, 09/2018, A5E33876626-AC
Clearance
To ensure unhindered access to the interfaces, the clearance indicated in the figure below is
required:
3.3.2
Fastening the connection box standard and connection box advanced
This section describes the mounting of the Anschuss box standard and the connection box
advanced on a flat metal surface, such as a control cabinet wall.
Requirement
● 4 M5 cylinder head screws
● 1 suitable screwdriver
Procedure
In this example, the fastening described is outside of a control cabinet wall.
1. Hold the connection box on the area where you want to mount it.
2. Mark locations for the mounting holes.
3. Drill holes or threaded holes for the 4 cylinder head screws according to your
requirements.
4. Attach the connection box.
See also
Dimension drawing for connection box standard and connection box advanced (Page 231)

Siemens SIMATIC HMI series Specifications

General

Series	SIMATIC HMI
Category	Control Panel
Display Type	TFT LCD
Touch Screen	Yes (resistive or capacitive, depending on model)
Processor	Varies by model (e.g., ARM-based processors)
Storage	Varies by model (e.g., Flash memory, microSD card slot)
Communication Interfaces	Ethernet, USB
Protection Class	IP65 (front panel), depending on model
Operating Temperature	0 to 50°C, -20 to 60°C
Power Supply	24 V DC
Memory	128 MB, 256 MB