Siemens SIMATIC HMI series User Manual

Commissioning a project
7.8 Managing WinCC options
Mobile Panels 2nd Generation
200 Operating Instructions, 09/2018, A5E33876626-AC
7.8
Managing WinCC options
You can install the following WinCC options on an HMI device:
● WinCC options supplied with WinCC for the Engineering System and Runtime
● WinCC options purchased in addition to WinCC for the Engineering System and Runtime
The HMI device type determines which WinCC options can be installed.
For an overview of available WinCC options, refer to "Introduction to WinCC".
Requirement
● The HMI device is connected to the configuration PC.
● The PG/PC interface is set.
● The HMI device is selected in the project tree.
● The HMI device is switched on.
Procedure
1. Select the "Options" command in the "Online > HMI device maintenance" menu.
All available WinCC options and those already installed are shown.
2. Click "Device status" to display the WinCC options installed on the HMI device.
3. To install a WinCC option on the HMI device, select the WinCC option with ">>" from the
list of installed WinCC options.
4. Click "<<" to remove a WinCC option from the HMI device.
5. To start the installation or removal, click "OK".
The selected WinCC options have been installed on or removed from the HMI device.

Siemens SIMATIC HMI series Specifications

General

Series	SIMATIC HMI
Category	Control Panel
Display Type	TFT LCD
Touch Screen	Yes (resistive or capacitive, depending on model)
Processor	Varies by model (e.g., ARM-based processors)
Storage	Varies by model (e.g., Flash memory, microSD card slot)
Communication Interfaces	Ethernet, USB
Protection Class	IP65 (front panel), depending on model
Operating Temperature	0 to 50°C, -20 to 60°C
Power Supply	24 V DC
Memory	128 MB, 256 MB