Safety instructions
2.1 General safety instructions
Mobile Panels 2nd Generation
34 Operating Instructions, 09/2018, A5E33876626-AC
Safety when working in and on electrical systems
Work in or on electrical systems may only be carried out by authorized persons. The
following safety regulations apply for the prevention of electric shock and electrocution:
1. Switch off the system
2. Secure the system to prevent it switching back on
3. Check the system to ensure it is de-energized
4. Ground and short the system
5. Cover or shield adjacent live parts
Note
These safety steps must always be taken in the above or
der before any work on electrical
systems. Once work on an electrical system is finished, cancel the safety steps starting with
the last and finishing with the first.
Label the electrical system in accordance with the applicable safety provisions when work is
to be carried out.
Always adhere to the safety provisions applicable in the country of use.
Strong high-frequency radiation
Observe immunity to RF radiation
The device has an increased immunity to RF radiation according to the specifications on
electromagnetic compatibility in the technical specifications.
Radiation exposure in excees of the specified immunity limits can impair device functions,
result in malfunctions and therefore injuries or damages.
Read the information on immunity to RF radiation in the technical specifications.
ESD
A device with electronic components is an electrostatic sensitive device. Due to their design,
electronic components are sensitive to overvoltage and thus to the discharge of static
electricity. Note the applicable regulations for ESD.
To Next Page
Loading...
Need help?
General
