Siemens SIMATIC HMI series User Manual

Installing system components
3.8 Selecting the connection box
Mobile Panels 2nd Generation
76 Operating Instructions, 09/2018, A5E33876626-AC
Connection box standard and connection box advanced
1. Switch off power supply to the connection box.
2. Open the connection box.
3. Disconnect the following cables from the connection box:
– All cables at the port X10
– The Ethernet cables at Fast Connector X1 and Fast Connector X2
4. Thread all connecting cables through the associated cable glands out of the connection
box.
5. Close the connection box.
6. Close off all cable glands with a cover.
7. Remove the four outermost screws used to fasten the connection box.
8. Remove the connection box from its mounting location.
See also
Connecting the KTP Mobile connecting cable to the connection box (Page 73)
Connecting the connection box (Page 59)
Installing system components (Page 43)

Siemens SIMATIC HMI series Specifications

General

Series	SIMATIC HMI
Category	Control Panel
Display Type	TFT LCD
Touch Screen	Yes (resistive or capacitive, depending on model)
Processor	Varies by model (e.g., ARM-based processors)
Storage	Varies by model (e.g., Flash memory, microSD card slot)
Communication Interfaces	Ethernet, USB
Protection Class	IP65 (front panel), depending on model
Operating Temperature	0 to 50°C, -20 to 60°C
Power Supply	24 V DC
Memory	128 MB, 256 MB