Siemens SIMATIC HMI TP1000F Mobile RO - Page 121

Parameterizing the Mobile Panel
5.13 Functions for service and commissioning
TP1000F Mobile RO
Operating Instructions, 08/2017, A5E39831415-AA
121
Procedure
1. Select "Next".
The Restore from external memory dialog is displayed. The dialog corresponds to the
"Backup to external memory" dialog in the section "Saving to external storage medium –
backup (Page 117)".
The "0 devices found" message appears if there is no storage medium in the HMI device
or if it is defective. Insert a storage media or replace the storage medium.
2. Select "Refresh".
The "Type of HMI interface" group is updated. The HMI device checks the storage
medium. Information about this storage medium is displayed in the "status information"
field.
3. Select the storage medium with the required backup in the "Type of HMI interface" group.
4. Select "Next".
The following dialog is displayed.
①
Backup file
5. Select the required file in the "Backup files on" group.
6. For information about the file selected, press "Details".
The following dialog appears:
①
Supported HMI devices
②
Image of the HMI device
③
Size of the selected file
④
Creation date of the backup file