Siemens SIMATIC HMI TP1000F Mobile RO User Manual

Safety instructions
2.2 Notes about usage
TP1000F Mobile RO
30 Operating Instructions, 08/2017, A5E39831415-AA
2.2
Notes about usage
NOTICE
HMI device approved for indoor use only
The HMI device may be damaged if operated outdoors.
Operate the HMI device indoors only.
Note
Using an Ethernet data transmission rate of 100 Mbps
The Ethernet data transmission rate of 10
Mbps is not supported by Mobile Panels 2nd
Generation.
Use a data transmission rate of 100
Mbps for communication with the device.
Industrial applications
The HMI device is designed for industrial applications. It conforms to the following standards:
● Requirements for emitted interference EN 61000-6-4 +A1
● Requirements for interference immunity EN 61000-6-2
Use in residential areas
Note
The HMI device is not intended for use in residential areas. The operation of HMI devices in
r
esidential areas can cause interference to radio and television reception.
If the HMI device is used in a residential area, you must take measures to achieve Limit
Class B conforming to EN 55011 for RF interference.
A suitable measure for achieving the RF interference level to Limit Class B, for example, is
the use of filters in power supply lines.
Individual acceptance is required for these measures.

Siemens SIMATIC HMI TP1000F Mobile RO Specifications

General

Brand	Siemens
Model	SIMATIC HMI TP1000F Mobile RO
Category	Measuring Instruments
Language	English