Installing system components
3.7 Connecting the KTP Mobile connecting cable to the connection box
TP1000F Mobile RO
64 Operating Instructions, 08/2017, A5E39831415-AA
Connecting the KTP Mobile connecting cable to the connection box
The connecting cable can be connected to the connection box using a circular connector.
The connector is coded to prevent faulty insertion. The connecting cable is described in the
section "KTP Mobile connecting cable (Page 14)".
1. Align the positioning mark of the connector with the positioning mark on the socket of the
connection box.
2. Insert the connector into the socket of the connection box.
Additional characteristics of the Mobile Panel are described in the section "Testing Mobile
Panel readiness for operation (Page 70)".
The information in the section "Fail-safe operation (Page 149)" also applies to fail-safe
HMI devices.
1. Pull the outer bushing.
Do not tilt the connector when removing it.
2. If you do not intend to use the HMI device with a different connection box, place the HMI
device in its wall-mounting bracket.
Wait for about 1 second after you have unplugged the connecting cable from the
connection box before you plug in the connecting cable again.
The socket of the connection box has IP65 degree of protection when the connecting
cable is plugged in or the cover cap in installed.
Connecting the connecting cable (Page 149)
To Next Page
Loading...
Need help?
General
