Installing system components
3.3 Installing the connection box standard and connection box advanced
TP1000F Mobile RO
Operating Instructions, 08/2017, A5E39831415-AA
37
Fastening the connection box compact
Read the instructions for work in and on electrical systems and on ESD in "General safety
instructions (Page 25)".
● 4 mounting clips
● 1 slotted screwdriver, size 2
1. Check for damage to the mounting seal on the connection box.
Do not install a connection box with a damaged mounting seal.
2. Insert the connection box in the mounting cutout.
Secure the connection box to prevent it from falling out.
3. Place one mounting clip into each of the four cutouts marked.
4. Fasten the mounting clips.
The permitted torque is 0.2 Nm.
You can find information on the electrical connection of the connection box in the section
"Connecting the connection box (Page 50)".
Installing the connection box standard and connection box
advanced
3.3.1
Mounting position and clearance
Mounting position
The connection box is designed to be mounted on a vertical surface of a stationary
enclosure.
The connection box standard and connection box advanced can be installed in any mounting
position.
To Next Page
Loading...
Need help?
General
