Siemens SIMATIC HMI TP1000F Mobile RO User Manual

Parameterizing the Mobile Panel
5.7 General settings
TP1000F Mobile RO
96 Operating Instructions, 08/2017, A5E39831415-AA
5.7.6.2
Setting the delay time
Introduction
After switching on the HMI device, the RemoteOperate Client application starts after a delay
time.
Requirements
You have opened the "Directories" tab in the "Transfer Settings" dialog with the
"Transfer" icon.
①
Location of the project file. Not relevant for the fail-safe HMI device.
②
Directory where the compressed source file of your project is saved
Not relevant for the fail-safe HMI device.
③
Location and start file for RemoteOperate Client
④
Selection box for the delay time
Note
Settings under "Path"
Do not change the settings in the "Path" field. If changes are made here, the RemoteOperate
Client software may not start the next time the HMI device is switched on.

Siemens SIMATIC HMI TP1000F Mobile RO Specifications

General

Brand	Siemens
Model	SIMATIC HMI TP1000F Mobile RO
Category	Measuring Instruments
Language	English