Siemens SIMATIC HMI TP1000F Mobile RO - Page 87

Parameterizing the Mobile Panel
5.6 Configuring operation
TP1000F Mobile RO
Operating Instructions, 08/2017, A5E39831415-AA
87
Requirement
● If you want to restore the factory settings:
The HMI device is connected in accordance with "Connecting PC and server (Page 46)".
● You have opened the "Device" tab in the "OP Properties" dialog with the "OP" icon.
Procedure
1. Click the "Reboot" button.
The following dialog appears:
①
Button for restart
②
Button for restoring factory settings and subsequent restart
2. Press one of the following buttons:
– "Reboot": Restart the HMI device immediately.
– "Prepare for Reset": Reset the HMI device to factory settings.
Note
When you press "
Prepare for Reset" the operating system and the server selection list
of the RemoteOperate Client software is deleted.
Restore the operating system as described in the section "Updating the HMI device
image (ProSave) (Page 125)".
– "No": Do not perform a restart, close the dialog.