Siemens SINAMICS G110M - Page 113

The DIP switches allows speci󹪝c functions of the converter to be set and are shown in the table
below.
Table 5-2 Function of the DIP switches
DIP switch Function
① Selects current or voltage input for the analog inputs.
Temperature sensor - sets the type of temperature sensor 󹪝tted to the motor.
87 Hz characteristic - set "ON" to operate the motor with the 87 Hz characteristic.
Electromechanical (EM) brake - select on if an EM brake is 󹪝tted.
Motor reverse
② Switching frequency - the user can select one of seven di󹪜erent switching frequencies.
Ramp-up and ramp-down timings - user can select from 0.1 seconds to 70 seconds
③ PROFIBUS address DIP-switch for use with the PROFIBUS and USS variant of the CU240M.
Examples of the DIP switches and their individual settings are illustrated in the 󹪝gures below.
([DPSOH6HWDGGUHVV 
352),%86866$''5(66

352),%86866$''5(66

Figure 5-7 PROFIBUS address DIP Switch
&200,66,21,1*',36:,7&+
(0
%5$.(
+=
7(03(5$785(
6(1625
9DOXH
6RIWZDUH
7HPSHUDWXUHVZLWFK
',3VZLWFK
SRVLWLRQ
62)7:$5(
:KHQWKH',3VZLWFKHVDUHLQWKH2))SRVLWLRQWKHYDOXHRIWKHIXQFWLRQLVGHILQHGE\WKHGHIDXOWSDUDPHWHUYDOXHRUDXVHUGHILQHGYDOXH
3$5$0(7(502',),&$7,21
,IWKH',3VZLWFKLVDFWLYDWHGIRUDVSHFLILFIXQFWLRQWKHSDUDPHWHUVIRUWKDWIXQFWLRQFDQQRWEHPRGLILHGE\HGLWLQJWKHDFWXDOSDUDPHWHU
02725
5(9(56(
37&
.7<
&XUUHQW
9ROWDJH
$,
9,
$,
9,
Commissioning
5.4 Quick commissioning
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL 111