Siemens SINAMICS G110M - Quick Commissioning with a PC

4XLFNVWRS2YHUULGH
$FNQRZOHGJHIDXOW
2))
212))
&RQWUROYLD$6L'XDO6ODYH
7UDQVPLW
'DWD6ODYH
7UDQVPLW
'DWD6ODYH
5HDG\YLD3/&
0RWRULVUXQQLQJ
5HFHLYH
'DWD6ODYH

5HFHLYH
'DWD6ODYH

7UDQVPLWFXUUHQWDQGDFWXDO
VSHHG
)DXOWRU:DUQLQJFRGH
5HTXHVW)DXOWDQG$ODUPFRGH
&\FOLFWUDQVPLVVLRQRIVSHHGVHWSRLQWRU
DF\OLF&77'DWD
6HOHFW$6ODYHRU%6ODYH
6HOHFW$6ODYHRU%6ODYH
',
',
;
;
',
',
;
$6L',
$6L',
$6L',
$6L',
$6L',
$6L',
$6L',
$6L',
$6L'2
$6L'2
$6L'2
$6L'2
$6L'2
$6L'2
$6L'2
$6L'2
$6L3
$6L35

$6L35
Figure 5-24 Default settings 34 - ASi Dual slave with setpoint
5.4.5 Quick commissioning with a PC
The screen forms that are shown in this manual show generally valid examples. The number of
setting options available in screen forms depends on the particular converter type.
Commissioning with a PC
The following interfaces - which are control unit dependent - are available:
Table 5-3 Connection possibilities for a PC
Type USB PROFIBUS PROFINET
PC connected to CU using USB cable PROFIBUS interface PROFINET interface
Interface Mini-USB M12 - 5 pole connec‐
tor
M12 - 4 pole connec‐
tor
Restrictions - up to 125 slaves None
In the following the commissioning via USB is described.
Commissioning
5.4 Quick commissioning
Distributed converter for SIMOGEAR geared motors
122 Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL