Siemens SINAMICS G110M - 5 Commissioning; Commissioning Guidelines

Commissioning
5
5.1 Commissioning guidelines
We recommend the following procedure:
1. De󹪝ne the requirements of
your application.
→ (Page 101)
2. Reset the converter when re‐
quired to the factory setting.
→ (Page 108)
3. Check whether the factory
setting of the converter is ap‐
propriate for your applica‐
tion.
If not, start with the basic
commissioning.
→ (Page 101)
→ (Page 111)
4. Check whether you need to
adapt the commissioning
DIP switches.
→ (Page 88).
5. If necessary, adapt the com‐
munications interface in the
converter.
→ (Page 162)
6. If necessary, set further func‐
tions in the converter.
→ (Page 155)
7. Save your settings.
→ (Page 137)
5IFDPOWFSUFSJT
JOTUBMMFE
$PNNJTTJPOJOHJT
DPNQMFUFE
1SFQBSFGPS
DPNNJTTJPOJOH
1FSGPSNRVJDL
DPNNJTTJPOJOH

'BDUPSZ
TFUUJOHTV꫾DJFOU

$POWFS
UFSXJUIGBDUPSZ
TFUUJOHT

'VSUIFS
DPOWFSUFS
GVODUJPOT
/P
:FT
"EWBODFEDPNNJTTJP
OJOH
6QMPBEJOHTFUUJOHT
SFRVJSFE
OPUVTFE

'JFMECVT
DPOOFDUJPO
$PO꫼HVSFUIF꫼FMECVT
JTBWBJMBCMF
OPUVTFE

%*1
TXJUDIFT
$IBOHF%*1TXJUDIFTGPS
BQQMJDBUJPO
NVTUCFBEBQUFE
꫼U
3FTUPSFUIFGBDUPSZ
TFUUJOHTGPSUIFDPOWFSUFS
/PPSVOLOPXO
:FT







Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL 99