Siemens SINAMICS G110M - Commissioning with the IOP-2

5.4.3 Commissioning with the IOP-2
Condition
The IOP-2 handheld is connected to the converter.
Commissioning tools (Page 100)
Description
Note
Screens and sequence may vary
The sequence of the commissioning process and the actual screens may vary according to the
following in󹪞uences:
• The 󹪝rmware version of the Intelligent Operator Panel 2 (IOP-2)
• The 󹪝rmware version of the converter being commissioned
• The speci󹪝c type of converter being commissioned.
In all the scenarios, the IOP-2 will always display the appropriate commissioning screens and
sequence for the converter to which it is connected.
6WDWXV
IBRXWSVPRRWK
,BDFWDEVYDOVPWK
QBDFWUSPVPRRWK
8BRXWSVPRRWK
+]
$
USP
9
:,=$5'6
%DVLF&RPPLVVLRQLQJ
%DVLF6DIHW\&RPPLVVLRQLQJ
)LHOGEXV,QWHUIDFH6HWWLQJV
3XPS6WDJLQJZLWK3,'
)DQ6WDJLQJZLWK3,'
3,':L]DUG
%RRVW
)DFWRU\5HVHW
<HV
1R
%DVLF&RPPLVVLRQLQJ
Select Wizards Select Basic Commissioning
wizard
Select Factory Reset (yes or
no)
)DFWRU\5HVHW
)DFWRU\5HVHWLVQRZEHLQJ
SHUIRUPHG
&RQWLQXH
%DVLF&RPPLVVLRQLQJ
&RQWURO0RGH
9IZLWK/LQHDU&KDUDFWHULVWLFV
9IZLWK)&&
9IZLWK4XDGUDWLF&KDUDFWHUL
9IZLWK3URJUDPPDEOH&KDUD
9I&RQWUROZLWK/LQHDU&KDUD
9IIRU7H[WLOH$SSOLFDWLRQV
9IZLWK)&&IRU7H[WLOH$SSOL
%DVLF&RPPLVVLRQLQJ
0RWRU'DWD
(XURSH+]N:
1$PHULFD+]+3
1$PHULFD+]N:
%DVLF&RPPLVVLRQLQJ
Select Continue Select Control Mode Select Motor Data
Commissioning
5.4 Quick commissioning
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL 113