9.2 Operating states indicated via LEDs
Table 9-1 Explanation of symbols for the following tables
LED is ON
LED is OFF
LED ashes slowly
LED ashes quickly
LED ashes with variable frequency
Please contact Technical Support for LED states that are not described in the following.
Table 9-2 Basic states
RDY Explanation
Temporary state after the supply voltage is switched on.
The converter is free of faults
Commissioning or reset to factory settings
A fault is active
Firmware update is active
Converter waits until the power supply is switched o and switched on again after a rmware
update
Alarms, faults and system messages
9.2 Operating states indicated via LEDs
Distributed converter for SIMOGEAR geared motors
346 Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL
To Next Page
Loading...
