Siemens SINAMICS G110M - Download from IOP-2 Operator Panel

Requirement
The following preconditions apply:
• The converter power supply has been switched on.
• The PC and converter are connected with one another via a USB cable or via the 󹪝eldbus.
• The converter settings are not protected against copying.
Download with active know-how protection with copy protection (Page 375)
Function description
Procedure





1. Go online.
2. Select "Online & diagnostics".
3. Select "Back up/reset".
4. Set the number of your data backup. You can back up 99 di󹪜erent settings on the memory
card.
5. Start the data transfer.
6. Wait until Startdrive has signaled that the data transfer has been completed.
7. Go o󹪠ine.
You have transferred your settings from a memory card to the converter.
❒
10.2.1.3 Download from IOP-2 operator panel
Overview
You can transfer the converter settings that are backed up on the IOP-2 operator panel back into
the converter.
Corrective maintenance
10.2 Downloading the converter settings
Distributed converter for SIMOGEAR geared motors
368 Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL