Siemens SINAMICS G110M - P0015 Default Settings

&RQWLQXH
)DFWRU\5HVHW<HV
&RQWURO0RGH9IZLWK/LQHDU&KDUDFWH
0RWRU'DWD(XURSH+]N:
6HOHFW0RWRU1DPHSODWH1R
0RWRU7\SH,QGXFWLRQPRWRU
&KDUDFWHULVWLF+]
6XPPDU\RI6HWWLQJV
%DVLF&RPPLVVLRQLQJ
6DYH
&DQFHO:L]DUG
6DYH6HWWLQJV
%DVLF&RPPLVVLRQLQJ
6HWWLQJVVDYHGVXFFHVVIXOO\
3UHVV2.WRFRQWLQXH
%DVLF&RPPLVVLRQLQJ

Summary of settings - Select
Continue
Save Settings Settings saved
6WDWXV
IBRXWSVPRRWK
,BDFWDEVYDOVPWK
QBDFWUSPVPRRWK
8BRXWSVPRRWK
+]
$
USP
9
0RWRU,'LQ3URJUHVV
0RWRU,'

Status Screen displayed On 󹪝rst ON command - Motor
ID is performed
5.4.4 p0015 Default settings
Default settings for the CU240M
The default settings that are available for the CU240M Control Modules are shown in the 󹪝gures
below. Default settings 7 is the default setting for the CU240M DP and CU240M PN Control
Modules, default settings 21 is the default settings for the CU240M USS Control Module and
default settings 30 is the default settings for the CU240M ASi Control Modules.
-RJ
-RJ
&RQWURODQG6HWSRLQW
)LHOGEXV
-RJ
)LHOGEXVLVQRWDFWLYH
&RQWUROYLD352),GULYH7HOHJUDPP
1R)XQFWLRQ
1R)XQFWLRQ
$FNQRZOHGJHIDXOW
$ODUP
)DXOW
', 
', 
', 
', 
', 
', 
', 
', 
;
;
;
;
',
',
',
'2
'2
',
Figure 5-10 Default settings 7 - Switch over between 󹪝eldbus and jogging using DI 3 (default DP/PN)
Commissioning
5.4 Quick commissioning
Distributed converter for SIMOGEAR geared motors
116 Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL