Siemens SINAMICS G110M - Analog Input as Setpoint Source

8.16.2 Analog input as setpoint source
Function description
$QDORJLQSXWDFWXDOYDOXH
0DLQVHWSRLQW
6FDOLQJ
6FDOLQJ
6XSSOHPHQWDU\VHWSRLQW
S
S
S
U
U
S
$,
$,
U>@


Figure 8-38 Example: Analog input 0 as setpoint source
In the quick commissioning, you de󹪝ne the preassignment for the converter interfaces.
Depending on what has been preassigned, after quick commissioning, the analog input can be
interconnected with the main setpoint.
Example
Setting with analog input 0 as setpoint source:
Parameter Description
p1070 = 755[0] Interconnects main setpoint with analog input 0
p1075 = 755[0] Interconnects supplementary setpoint with analog input 0
Parameters
Number Name Factory setting
r0755[0 … 1] CO: CU analog inputs, actual value in percent - %
p1070[C] CI: Main setpoint Dependent on the
converter
p1071[C] CI: Main setpoint scaling 1
r1073 CO: Main setpoint active - rpm
p1075[C] CI: Supplementary setpoint 0
p1076[C] CI: Supplementary setpoint scaling 1
r1077 CO: Supplementary setpoint e󹪜ective - rpm
Advanced commissioning
8.16 Setpoints
Distributed converter for SIMOGEAR geared motors
260 Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL