6.2.2 Automatic upload
Overview
We recommend that you insert the memory card before switching on the converter. The
converter automatically backs up its settings on the inserted memory card and always keeps it
up to date.
Precondition
The converter power supply has been switched o.
Function description
Procedure
1. Insert an empty memory card into the converter.
Note
Accidental overwrite of the converter settings
When the supply voltage is switched on, the converter automatically accepts the settings
already backed up on the memory card. If you use a memory card on which settings are
already backed up, you will overwrite the settings of the converter.
• Use an empty memory card for the rst automatic back-up of your settings.
Note
Unintentional rmware update
If the memory card contains a converter rmware, the converter may perform a rmware
update after the supply voltage has been switched on.
• Before inserting the memory card, ensure that it is empty.
Firmware upgrade and downgrade (Page 379)
2. Switch on the power supply for the converter.
After the power supply has been switched on, the converter copies its changed settings to the
memory card.
❒
Uploading the converter settings
6.2 Uploading to the memory card
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL 139
To Next Page
Loading...
