Siemens SINAMICS G110M - Limit Position Control

8.9 Limit position control
Overview
0LQXVOLPLWSRVLWLRQ3OXVOLPLWSRVLWLRQ
0LQXVOLPLWVZLWFK3OXVOLPLWVZLWFK
An end position is a position in the direction of motion of a machine component where motion
stops as a result of the inherent mechanical design. A limit switch is a sensor that signals that the
end position has been reached.
The end position control of the converter controls the motor depending on 2 limit switch signals:
• When an end position is reached, the converter stops the motor.
• At one end position, the converter prevents the motor from moving the machine
components further in the direction of this end position.
Function description
6WDUWOLPLWVZLWFK
3OXVOLPLWVZLWFK
0LQXVOLPLWVZLWFK
/LPLWVZLWFK212))
/LPLWVZLWFK2))
/LPLWVZLWFKD[LVVWDWLRQDU\
VWDQGVWLOO
6SHHGDFWXDOYDOXH
3OXVOLPLWVZLWFKDFWXDWHG
0LQXVOLPLWVZLWFKDFWXDWHG
6SHHGVHWSRLQWDIWHUILOWHU
S
S
S
U
U
U
U
W
W
W
W
W
U
W
U
W
W
W
U
W

Figure 8-22 End position control of the converter
Advanced commissioning
8.9 Limit position control
Distributed converter for SIMOGEAR geared motors
220 Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL