A.1.3 Firmware version 4.7 SP9
Table A-3 New functions and function changes in rmware 4.7 SP9
Function SINAMICS
G120 G120D
1 Support of PM240‑2 FSG Power Modules - - ✓ ✓ ✓ ✓ - - -
2 Support of PM240‑2 Power Modules in push-through technology, frame
sizes FSD … FSF, for the following voltages:
• 3 AC 200 V … 240 V
• 3 AC 380 V … 480 V
• 3 AC 500 V … 690 V
- - ✓ ✓ ✓ ✓ - - -
3 Shortened switch-on time for PM330 Power Modules - - ✓ - - - - - -
4 Expansion of the support for 1FP1 synchronous-reluctance motor with the
following converters:
• SINAMICS G110M
• SINAMICS G120D
• SINAMICS G120 with CU240B‑2 or CU240E‑2 Control Unit
A PM240‑2 Power Module is required to operate a 1FP1 synchronous-reluc‐
tance motor with SINAMICS G120
✓ - ✓ ✓ ✓ - ✓ - -
5 Support of 1FP3 synchronous-reluctance motors
A PM240‑2 Power Module is required to operate a 1FP3 synchronous-reluc‐
tance motor along with a selective release from SIEMENS
- - ✓ - - - - - -
6 Support of 1LE5 induction motors - ✓ ✓ ✓ ✓ ✓ - - -
7 The converter supports forming of the PM330 Power Module DC link capac‐
itors
- - ✓ - - - - - -
8 Setting option for two output reactors using parameter p0235 at the SI‐
NAMICS G120C and SINAMICS G120 with PM240-2 FSD … FSF Power Module
- ✓ ✓ ✓ ✓ ✓ - - -
9 Eciency-optimized operation of induction motors
Improved method "Eciency optimization 2"
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
10 New setting option for the "Technology application" p0500 = 5 during quick
commissioning
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
11 Expansion of the available PROFIdrive telegrams in the SINAMICS G120C to
include telegram 350
- ✓ ✓ ✓ ✓ ✓ - - -
12 An SSI encoder can be parameterized as motor encoder - - - - - ✓ - ✓ -
13 Expansion of the "Basic positioner" function to include the feedback signal
from traversing blocks to the higher-level control system
- - - - - ✓ - ✓ -
14 Feedback signal supplemented to indicate that a memory card is not inser‐
ted in the converter:
• Parameter r9401 as BiCo parameter for the optional feedback signal to
the higher-level control system.
• New alarm A01101
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
Appendix
A.1 New and extended functions
Distributed converter for SIMOGEAR geared motors
400 Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL
To Next Page
Loading...
Need help?
General
