Siemens SINAMICS G110M - Setpoints; Overview

8.16 Setpoints
8.16.1 Overview
The converter receives its main setpoint from the setpoint source. The main setpoint generally
speci󹪝es the motor speed.
,QYHUWHUFRQWURO
6HWSRLQWV
6HWSRLQWSURFHVVLQJ
/RZHU
)L[HGVHWSRLQWV
0RWRUL]HGSRWHQWLRPHWHU
$QDORJLQSXW
(OHFWURPHFKDQLFDO
SRWHQWLRPHWHU
5DLVH
6XSSOHPHQWD
U\VHWSRLQW
0DLQVHWSRLQW
-RJJLQJ
VHWSRLQW
7HFKQRORJ\
FRQWUROOHU
6HWSRLQWIURP
RSHUDWRUSDQHO
RU3&


Figure 8-37 Setpoint sources for the converter
You have the following options when selecting the source of the main setpoint:
• Converter 󹪝eldbus interface
• Analog input of the converter
• Electromechanical potentiometer
• Motorized potentiometer emulated in the converter
• Fixed setpoints saved in the converter
You have the same selection options when selecting the source of the supplementary setpoint.
Advanced commissioning
8.16 Setpoints
Distributed converter for SIMOGEAR geared motors
258 Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL