Siemens SINAMICS G110M - Uploading to the Memory Card; Recommended Memory Cards

6.2 Uploading to the memory card
6.2.1 Recommended memory cards
Function description
Table 6-1 Memory cards to back up converter settings
Scope of delivery Article number
Memory card without 󹪝rmware 6SL3054-4AG00-2AA0
Memory card with 󹪝rmware V4.7 6SL3054-7EH00-2BA0
Memory card with 󹪝rmware V4.7 SP3 6SL3054-7TB00-2BA0
Memory card with 󹪝rmware V4.7 SP6 6SL3054-7TD00-2BA0
Memory card with 󹪝rmware V4.7 SP9 6SL3054-7TE00-2BA0
Memory card with 󹪝rmware V4.7 SP10 6SL3054-7TF00-2BA0
Memory card with 󹪝rmware V4.7 SP13 6SL3054-7TG00-2BA0
Further information
Using memory cards from other manufacturers
The converter only supports memory cards up to 2 GB. SDHC cards (SD High Capacity) and SDXC
cards (SD Extended Capacity) are not permitted.
If you use a di󹪜erent SD memory card, then you must format it as follows:
• Insert the card into your PC's card reader.
• Command to format the card:
format x: /fs:fat or format x: /fs:fat32 (x: Drive code of the memory card on your PC.)
Functional restrictions with memory cards from other manufacturers
The following functions are either not possible – or only with some restrictions – when using
memory cards from other manufacturers:
• Licensing functions is only possible using the recommended memory cards.
• Know-how protection is only possible with one of the recommended memory cards.
• In certain circumstances, memory cards from other manufacturers do not support writing or
reading data from/to the converter.
Uploading the converter settings
6.2 Uploading to the memory card
Distributed converter for SIMOGEAR geared motors
138 Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL