Siemens SINAMICS G110M - 9 Alarms, faults and system messages

Alarms, faults and system messages
9
9.1 Status LED overview
LED status indicators
The Power Module has number of dual-colour LEDs which are designed to indicate the
operational state of the converter. The LEDs are used to indicate the status of the following
states:
• General fault conditions
• Communication status
The location of the various LEDs on the Power Module and Communications and Power Interface
are shown in the 󹪝gure below. The Power Interface is attached to the terminal housing.




6WDWXV/('V
&RPPXQLFDWLRQV3RZHU,QWHUIDFH&3,
352),1(7/('V
Figure 9-1 Status LED locations
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL 345