Siemens SINAMICS G110M - Interconnecting Signals in the Converter; Fundamentals

A.2 Interconnecting signals in the converter
A.2.1 Fundamentals
The following functions are implemented in the converter:
• Open-loop and closed-loop control functions
• Communication functions
• Diagnosis and operating functions
Every function comprises one or several blocks that are interconnected with one another.
0RWRUL]HGSRWHQWLRPHWHUVHWSRLQW
DIWHUWKHUDPSIXQFWLRQJHQHUDWRU
0RWRUL]HGSRWHQWLRPHWHU
VHWSRLQWORZHU
0RWRUL]HGSRWHQWLRPHWHU
VHWSRLQWKLJKHU
,QSXWV2XWSXW3DUDPHWHU
S
U
S
023
Figure A-1 Example of a block: Motorized potentiometer (MOP)
Most of the blocks can be adapted to speci󹪝c applications using parameters.
You cannot change the signal interconnection within the block. However, the interconnection
between blocks can be changed by interconnecting the inputs of a block with the appropriate
outputs of another block.
The signal interconnection of the blocks is realized, contrary to electric circuitry, not using
cables, but in the software.
0DLQVHWSRLQW
0RWRUL]HGSRWHQWLRPHWHU
VHWSRLQWDIWHUWKH
UDPSIXQFWLRQJHQHUDWRU
0RWRUL]HG
SRWHQWLRPHWHU
VHWSRLQWORZHU
0RWRUL]HG
SRWHQWLRPHWHU
VHWSRLQWKLJKHU
352),GULYH
UHFHLYH3='
ELWE\ELW
S

U
U
S
U
S
023
Figure A-2 Example: Signal interconnection of two blocks for digital input 0
Appendix
A.2 Interconnecting signals in the converter
Distributed converter for SIMOGEAR geared motors
408 Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL