Siemens SINAMICS G110M - Page 151

Parameter
Table 7-2 Parameters that can be changed with active know-how protection
Number Name
p0003 Access level / Acc_level
p0010 Drive commissioning parameter 󹪝lter / Drv comm par_󹪝lt
p0124[0...n] CU detection using LED / CU detect LED
p0791[0...1] CO: Fieldbus analog outputs / Fieldbus AO
p0970 Reset drive parameters / Drive par reset
p0971 Save parameters / Sav par
p0972 Drive unit reset / Drv_unit reset
p2040 Fieldbus interface monitoring time / Fieldbus t_monit
p2111 Alarm counter / Alarm counter
p3950 Service parameter / Serv par
p3981 Acknowledge drive object faults / Ackn DO faults
p3985 Master control mode selection / PcCtrl mode select
p7761 Write protection / Write protection
p8402[0...8] RTC daylight saving time setting / RTC DST
p8805 Identi󹪝cation and Maintenance 4 Con󹪝guration / I&M 4 Con󹪝g
p8806[0...53] Identi󹪝cation and Maintenance 1 / I&M 1
p8807[0...15] Identi󹪝cation and Maintenance 2 / I&M 2
p8808[0...53] Identi󹪝cation and Maintenance 3 / I&M 3
p8809[0...53] Identi󹪝cation and Maintenance 4 / I&M 4
p8980 EtherNet/IP pro󹪝le / Eth/IP pro󹪝le
p8981 EtherNet/IP ODVA STOP mode / Eth/IP ODVA STOP
p8982 EtherNet/IP ODVA speed scaling / Eth/IP ODVA n scal
p8983 EtherNet/IP ODVA torque scaling / Eth/IP ODVA M scal
p9400 Safely remove memory card / Mem_card rem
p9484 BICO interconnections search signal source / BICO S_src srch
Table 7-3 Parameters that can be read with active know-how protection
Number Name
p0015 Macro drive unit / Macro drv unit
p0100 IEC/NEMA Standards / IEC/NEMA Standards
p0170 Number of Command Data Sets (CDS) / CDS count
p0180 Number of Drive Data Sets (DDS) / DDS count
p0300[0...n] Motor type selection / Mot type sel
p0304[0...n] Rated motor voltage / Mot U_rated
p0305[0...n] Rated motor current / Mot I_rated
p0505 Selecting the system of units / Unit sys select
p0595 Technological unit selection / Tech unit select
p0730 BI: CU signal source for terminal DO 0 / CU S_src DO 0
Protecting the converter settings
7.2 Know-how protection
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL 149