Siemens SINAMICS G110M - Page 200

• IND, bit 0 … 7 (page index): = 0 hex (o󹪜set 0 corresponds to 0 hex)
• PWE1, Bit 0 … 15: = 2D2 hex (722 = 2D2 hex)
• PWE2, Bit 10 … 15: = 3F hex (drive object - for SINAMICS G120, always 63 = 3f hex)
• PWE2, Bit 0 … 9: = 2 hex (Index of Parameter (DI 2 = 2))
3DUDPHWHUFKDQQHO
3:(KLJKUGZRUG3:(ORZWKZRUG,1'QGZRUG
3DJHLQGH[3DUDPHWHUQXPEHU6XELQGH[3DUDPHWHUYDOXH
3.(VWZRUG
'ULYH2EMHFW,QGH[
$.







Figure 8-14 Parameter channel to assign digital input 2 with ON/OFF1
Function description
AK: Request and response ID
Table 8-28 Request identi󹪝ers, control → converter
AK Description Response identi󹪝er
positive nega‐
tive
0 No request 0 7 / 8
1 Request parameter value 1 / 2 7 / 8
2 Change parameter value (word) 1 7 / 8
3 Change parameter value (double word) 2 7 / 8
4 Request descriptive element
1)
3 7 / 8
6
2)
Request parameter value (󹪝eld)
1)
4 / 5 7 / 8
7
2)
Change parameter value (󹪝eld, word)
1)
4 7 / 8
8
2)
Change parameter value (󹪝eld, double word)
1)
5 7 / 8
9 Request number of 󹪝eld elements 6 7 / 8
1)
The required element of the parameter is speci󹪝ed in IND (2nd word).
2)
The following request IDs are identical: 1 ≡ 6, 2 ≡ 7 and 3 ≡ 8.
We recommend that you use identi󹪝ers 6, 7 and 8.
Table 8-29 Response identi󹪝ers, converter → control
AK Description
0 No response
1 Transfer parameter value (word)
2 Transfer parameter value (double word)
3 Transfer descriptive element
1)
4 Transfer parameter value (󹪝eld, word)
2)
5 Transfer parameter value (󹪝eld, double word)
2)
6 Transfer number of 󹪝eld elements
Advanced commissioning
8.6 Drive control via PROFIBUS or PROFINET
Distributed converter for SIMOGEAR geared motors
198 Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL