Siemens SINAMICS G110M - Page 219

Data exchange
5HTXHVW
PDVWHUVODYH
3,9VKDUH
3,9VKDUH
$QVZHU
VODYHPDVWHU
0DQXIDFWXUHUVSHFLILFH[FKDQJHUHTXHVW
,QGH[
5HDGOHQJWK
:ULWHOHQJWK
0DQXIDFWXUHUVSHFLILFH[FKDQJHUHTXHVW2.
'KH[)KH[ KH[ KH[3.(,1'3:(3:(
'KH[3.(,1'3:(3:(
Reading data
The data for the last write or exchange request is read
5HTXHVW
PDVWHUVODYH
3,9VKDUH
$QVZHU
VODYHPDVWHU
0DQXIDFWXUHUVSHFLILFUHDGUHTXHVW
,QGH[
5HDGOHQJWK
0DQXIDFWXUHUVSHFLILFUHDGUHTXHVW2.
KH[)KH[KH[
KH[3.(,1'3:(3:(
Writing data
5HTXHVW
PDVWHUVODYH
$QVZHU
VODYHPDVWHU
0DQXIDFWXUHUVSHFLILFZULWHUHTXHVW
,QGH[
:ULWHOHQJWK
0DQXIDFWXUHUVSHFLILFZULWHUHTXHVW2.
3,9VKDUH
KH[)KH[KH[
KH[
3.(,1'3:(3:(
In the event of a fault, the converter sends the following telegram as response to the master:
KH[ KH[3:(
.
Value for PWE: Fault table from AS-i System Interface Manual (https://
support.industry.siemens.com/cs/gb/en/view/1171856).
Advanced commissioning
8.7 Control via AS-i
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL 217