Procedure
1. Select in the "Conguration" project tree.
2. Select under the "Units" tab.
3. Select the system of units.
4. Select the technological unit of the technology controller.
5. Select the motor standard.
6. Save your settings.
7. Go online.
The converter signals that oine, other units and process variables are set than in the
converter itself.
8. Accept these settings in the converter.
You have selected the motor standard and system of units using STARTER.
❒
Advanced commissioning
8.14 Selecting physical units
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL 241
To Next Page
Loading...
